Das Filter Blog

How to Split and Seal a Blunt (Cigarillo Wrap)

By Das Filter Team5 min read

Close-up of hands preparing a roll over a tray with ground flower and dried leaf wrap pieces

Quick answer: Split the cigarillo along its seam, empty the tobacco, soften the wrap so it bends without cracking, refill evenly, tuck and roll it closed, then seal the outer edge with a light damp finger and let it dry. An 8mm tip fits a standard cigarillo-size blunt; use 12mm for a fat wrap. Tobacco wraps contain nicotine and are 21+; tobacco-free seekers should pick hemp or leaf wraps instead.

This guide is only the split, empty, soften and seal work. The full roll with a crutch is in how to roll a blunt. Wrap materials are compared in types of blunt wraps.

Tobacco note (read this first)

Cigarillos and tobacco blunt wraps contain tobacco and nicotine. Under US federal law they are tobacco products sold to adults 21 and older. If you want a tobacco-free blunt, use a hemp wrap or a pre-rolled leaf cone labeled tobacco-free, not a split cigarillo.

What you need

ItemWhy
A cigarillo or blunt wrapSomething to split, or a flat wrap already open
A fingernail or clean knife tipTo open the seam without shredding the wrap
A barely damp fingertipTo soften and to seal
Ground flower, medium grindEven fill burns straighter
Optional: 8mm or 12mm tipSets the mouth end and makes the first tuck easier

Step 1: Find the seam and split it

Hold the cigarillo so you can see the long glue seam. Run a fingernail or the tip of a clean knife along that seam from one end to the other. Peel the wrap open into a flat sheet. Don't dig into the wrap itself; you're only cracking the seam.

If you're starting with a flat hemp or tobacco sheet wrap, skip the split and go to soften.

Step 2: Empty it

Dump out all the tobacco filling onto a tray or into the trash. Brush the wrap clean so leftover shreds don't sit under your flower. Leftover tobacco in the wrap still means nicotine in the finished blunt.

Step 3: Soften the wrap

Dry wraps crack on the tuck. Run a barely damp fingertip along the inside of the wrap, or breathe on it, until it bends without splitting. Stop before it gets wet or sticky. A soaked wrap tears and burns unevenly later.

Step 4: Set a tip (optional) and refill

If you're using a tip, lay it across one end flush with the edge:

BluntTip
Standard cigarillo-size8mm
Fat blunt or large wrap12mm

Our Big Boy tips are 8mm x 37mm for a standard blunt; the 12mm is 12mm x 30mm for a fat wrap.

Spread flower evenly from the tip to the far end. Keep the line level. Lumps on one side are what make a blunt canoe. A cigarillo-size wrap usually takes about 1 to 1.5 grams; large wraps take more. Fill evenly rather than chasing a set weight. Whether you need a tip at all is covered in do blunts need a filter tip.

Step 5: Tuck and roll closed

Start at the tip end. Tuck the near edge of the wrap under the filling and work the tuck toward the far end, the same idea as in how to roll a joint. Roll it up until only the outer sealing edge is left free.

Step 6: Seal the seam

Lightly wet the outer edge with a fingertip and press it down along the full length of the seam. Gaps in the seal are where air sneaks in and the burn runs.

Then dry it: either let it sit a few minutes, or pass a lighter flame under the seam quickly without touching the wrap. A damp seam is more likely to open back up.

How do you fix a canoed blunt?

A canoed blunt burns down one side first. Usual causes:

CauseFix
Uneven fillPack the slow side gently with a thin stick, or rebuild next time with a level line
Loose or wet seamReseal gaps; dry the seam before lighting
Lit on one cornerToast the whole rim while turning, like how to light a joint
Dry wrap that crackedSoften next wrap before you tuck

If one side is racing, even the rim with the flame on the slow side while you turn it. More in why does my joint canoe.

Frequently asked questions

How do you split a blunt or cigarillo?

Find the seam, run a fingernail or a clean knife tip along it from end to end, open the wrap flat, and dump out the tobacco filling. Go slow so you don't tear the wrap.

How do you seal a blunt wrap?

After you tuck and roll it closed, lightly wet the outer edge and press it down along the seam. Let it dry for a few minutes, or pass a lighter flame under the seam quickly without touching it.

Why does my blunt canoe?

Uneven fill, a wet or loose seam, or lighting only one side of the tip. Pack evenly, seal the full length, and toast the whole rim while you turn it.

How do you stop a blunt wrap from cracking?

Dry wraps crack. Soften the wrap with a barely damp fingertip, or breathe on it, until it bends without splitting. Don't soak it.

Do tobacco blunt wraps contain nicotine?

Yes. Cigarillos and tobacco wraps contain tobacco and nicotine and are sold 21+. For a tobacco-free wrap, look for hemp or leaf wraps labeled tobacco-free.


Products are for adults 21+.

Shop Das Filter

Products in this post

Activated carbon filter tips, papers and rolling gear, made and shipped from Austin, TX.

See all products Buying for a shop? Wholesale